Hello
I would like to extend my Eisbaer Pro Aurora 420 with a second CPU AIO (I have a dual-system case).
I only have room in the case for a 1x140mm radiator on the rear exhaust fan, and the CPU is low power so I am not worried about the cooling capacity.
But there is no off-the-shelf 140mm...
For the double nipple do you mean this one:
https://www.alphacool.com/shop/anschluesse/anschluesse-zubehoer/20695/alphacool-eiszapfen-doppelnippel-drehbar-g1/4-ag-auf-g1/4-ag-deep-black
?
I only wish I knew all this before mounting the radiator. Thermal paste is a necessary evil !
Thank you...
To open the tube, do you mean I should cut it ?
Is the a way to fit the sensor in between the pump and the existing tube ? Or between the tube and radiator ? I assume there is a thread in the pump (and in the radiator), so maybe I could use it ?
Thank you,
Adrian Constantin
Hello,
The Square Acetal looks right for me, but I am still confused on the "appropriate fittings" to combine it with the Eisbaer Pro Aurora 420. The accessories listed on the sensor page use "High Flow" fittings. So is the thread bellow going to fit my sensor and with the Eisbaer ?
Alphacool...
Hello
I have Eisbaer Pro Aurora 420. Is there a compatible temperature sensor (and temprature + flow rate) that I could buy for it ?
It looks to me the tube could be disconnected from the pump (to allow sensor installation), or maybe there is a sensor that can connect using the quick release...
Hello
I would like to build a combined AIO loop with EisBaer Aurora 420 CPU and EisWolf 2 Radeon.
But then how do I control the pump and the fans ? Because the motherboard would only react to the CPU temperature, and not the GPU temperature. Is there a supported temperature sensor for the...
My build is not ready, as I run into issues trying to setup 420mm push-pull in a case not designed for it, but here is an image of the 750D case on my table. I believe there should be room for a water loop, if the pump + reservoir fits under the video card. I might also have to move the HDD out...
Thank you
I believe I have a reference design for my AMD Radeon RX 6800 XT Midnight Black. It is supposed to be identical to the AMD released RX6800 XT (non-Midnight). Is there a way for me to check the board design to be sure ?
The resulting loop above is kind of expensive for me, but I see...
Hello,
I would like something like the Eiswolf 2 AIO - Radeon RX 6000, but with 280mm radiator instead of the 360mm one, for the front side of my Corsair 750D Airflow case.
Is there an option for this ? Do I have to assemble such a loop myself from parts ? I would much prefer an AIO (as I am...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.