Recent content by Ionut

Thank you! I though so myself :), but had to ask In description there is a "small" mistake: it say that the triangle show the IN/OUT ports, but if so, then the inlet would have been the one on the right

Hi! I have a stupid question: for this waterblock, the intake is on the left or on the right? I mean, the small triangles indicate the waterflow or the inlet/outlet? As far as I can see from pictures (and actual block), the inlet should be the one on the left (passing over VRM first, then over...

I know that, I just wanted to make sure that I can use my pump at maximum settings (mostly for pressure concerns, I have a pretty restrictive loop). At step 3 (currently), the pump is rated for 2.2 m head pressure. At step 5 (max), is 4.25 m.

So, in practice....my pump is not putting up 340 l / h ? :p Anyway, the GPU block is feeded directly by the pump; there are only two fittings (and the tube, of cource) between them. I would feel much better if I could find a way to increase the flow rate of the block; I can do that either by...

I have a question & request regarding the Alphacool HF 14 Smart Motion universal block ( https://www.alphacool.com/shop/gpu-water-cooler/amd-gpu/11088/alphacool-hf-14-smart-motion-universal-copper-edition?c=20593 ): in description / technical specifications is stated that it support a flow of up...

I've actualy done this setup (1st option, single loop), but a little different. Instead of mountig the pumps far apart in the loop, I've purchased a top similar to yours, dismantle the Eisbaer for the pump and mount them (pump and top) at the outlet of the Eisstation (of course, I had to...

Sorry to disturb you again....but I have this crazy ideea: buy the Eisdecke DC-LT dual Plexi top and a CPU block, dismantle the Eisstation and Eisbaer, mount their pumps on the plexi top and create a custom water loop: Dual plexi top - GPU - CPU - 1st radiator - 2nd radiator - reservoir - back...

Thank you very much for your prompt reply! One question: if I run them in serial, shouldnt I try to make them run at the same speed (thus the ideea of a single power connector) ? If I run them on different headers, I probably shoud try to make identical settings for both of them, right?

Hello, I've also posted this thread in "Builds & Mods" section, but I've received no answer so far. I'm a proud owner of an AIO Eisbaer 360LT CPU cooler, and recently I've come out with the ideea of expanding it. I had already customize it by replacing the tubes (with clear ones), the radiator...

Hello, I'm a proud owner of an AIO Eisbaer 360LT CPU cooler, and recently I've come out with the ideea of expanding it. I had already customize it by replacing the tubes (with clear ones), the radiator (with an 360mm x 45mm one) and also added a reservoir, but now I want to make my GPU also...