Recent content by R9 Fury

  1. R

    How much extra pressure for an Eisbaer 420 ?

    But the loop is just the original Eisbaer 420 with 2 extra tubes, each around 40cm long, so in the worst case scenario, that's an extra... 0.0010005 Pa*second for mu the dynamic viscosity of water at 20°C (it decreases with higher temps) So the Hagen-Poiseuille equation gives : Delta_P =...
  2. R

    How much extra pressure for an Eisbaer 420 ?

    No, it's the original Eisbaer 420's pump, with 70 L/h.
  3. R

    How much extra pressure for an Eisbaer 420 ?

    OK, so I detached the radiator from the case, in order to shake it like a madman while holding it at a lower height than the pump (didn't want to disconnect the tubes to take the whole AIO out of the case though), and that did push a few air bubbles to the pump, so I could add maybe an extra...
  4. R

    How much extra pressure for an Eisbaer 420 ?

    Fail on my behalf... I forgot 10m of water = 1 bar, not 1m...
  5. R

    How much extra pressure for an Eisbaer 420 ?

    Hi all ! I recently acquired an Eisbaer 420, and for maximum performance at the lowest possible noise level, decided to install the radiator outside of the PC case, a Corsair Carbide 300R, some 25mm above the mesh on the top and with the rearmost third of the radiator sticking out over the back...
Top