Managed to get constant 100% load using passmark BurnInTest together with CPU-Z stress test.
After 1h 30 minutes peak T 79° with TDP 240W in closed case. Seems to be good enough. I'm right?
Case/radiator fans ran at approx 900 rpm measured through case's built in controller. I believe it is...
Actually 39-40° is while in BIOS menus. For some reason CPU runs at 4300MHz. (it's maximum without turbo)
Test installed windows yesterday to run some stress. While idling it runs like 26-28°
Run Intel CPUBurn/Prime95 and CPU gets to 72° after 30 minutes of test. Hoses become warm. Can't get...
GB Auros master can control voltage to fans. It has autodetect for control method. By default it sets 1800rpm but T is still 39-40 (?)
So current position of pump is correct? Window is towards top 2 fans.
There are 3 fans pushing to radiator
I'm back with some results and questions :)
The hoses are still too short to install radiator on the top of this case.
It needs something like 3-5cm more. Actually I was able to put pump on CPU, but not as required by manual - window facing upwards.
So I put it on front panel as you can see. Is...
Thanks for response. Are you sure about 240? I read reviews and these show, that this CPU goes over 300W+ under load,
Any way, I would prefer have some area for maneuvre and low noise under general load. Probably I'll add 2080Ti in loop later.
In regard to hoses length - can't find...
Newbie going for water cooling )
I'm going to cool intel i9 10920x cpu and need some help.
Read some reviews and appears that Alphacool Eisbaer 420 is good choice for that CPU.
Is that true? No OC is planned.
But here is the problem: hoses are too short for that case, as reviews show...