Eiswolf 2 questions?

[Tomate]

Hello,

I recently acquire a Eiswolf 2 AIO for my 3080 FE and have a few question.
I'm trying to manage fan/pump speed to be control by GPU temp.
In the process when controlling pump speed the Geforce RTX logo led is switching off at some pump speed, steady at some and blinking at some, can you confirm this is normal behavior and can we change it?

Thanks,

 

[Thomas_S]

This happens because it is not intended to regulate the pump according to GPU temperature. The pump should run constantly at 12 V. If this happens, the LEDs should light up constantly. It also makes little sense to throttle the pump.

 

[Tomate]

Ok, so I should put it to 100% ?

 

[Pro4TLZZ]

Hi.

I have this aio and gpu as well.

From the block there are 2 cables. One is 3 pin pump header. You should plug this into aio_pump on your motherboard and set it to DC mode.

I wouldn't try to use a curve with the pump.

I've not seen the RGB disable when the system is on

 

[Thomas_S]

Ok, so I should put it to 100% ?

Yes, it is advisable for the pump. Among other things, why do you want to reduce a flow rate (standard, ignoring the restrictiveness of the radiator, quick-acting fasteners, etc.) of 75L/h? According to support, the pump even stops when you regulate below a value of 9V. (which can also cause the RGBs to fail: pump off/RGBs off!)