Suggestion: Acrylic version of the EISSTATION DC-LT-RESERVOIR

H

hypnonotic

New member
I use an EISSTATION 40 in my SFF build and the only issue I have with it is that I cannot tell when there are bubbles in it and my loop needs to be topped off.

It would be very cool if you guys sold a replacement top for the reservoir that is made from clear acrylic that way I could see the fluid inside of it. While the whole reservoir could be made in acrylic, I would be very happy with jut a replacement lid for it.

As a side node, a DRGB version of the reservoir would also be cool :D

Thanks!
 
H

hypnonotic

New member
Hi, thanks for the suggestion, but the eisstation VVP is actually too large. It measures 100x100x80mm, I only have 60mmx60mmx100mm of volume available in the case. The eisstation 40 fits nicely within that

I'm building in a FormD T1 so space is extremely limited. This is not my build, but the placement of the reservoir is roughly the same:
k0vmb7u6diu51.jpg
 
R

Redulon

Member
Okay. Then place a quick release in this horizontal tube.
Then you can add a separate, small reservoir to refill and check for bubbels/air in the system.
If everything is okay, u can demount the reservoir and close the original loop, without loosing fluid, or add new air to the system :)
 
You must log in or register to reply here.
Top