Water temperature sensor for Eiswolf 2 AIO


New member
Based on this thread I bought a Eiszapfen, but found out too late that I don't have a Eisbaer, but an Eiswolf 2 (AIO for a 3090). The Eiszapfen seems a lot longer than the filling port on the radiator could handle. Is there any extension which would enable the Eiszapfen to be plugged in the loop? Or should I go with another water temperature sensor?
Last edited:


Staff member

you would either need a temperature sensor with a short sensor like following article or you can try an extension fittings. But I can´t say if that would still fit in your case.