Problems to vent my Eiswolf 2 on RTX3090

[Alexander Madenach]

Hi @all,
i have trouble to get the bubbles out of my Eiswolf 2. The Rad is above the pomp, but for installation reasons, i have had to split both parts by the quick releases an put them togehter again. So, i can´t evacuate the air, no matter i manually get the bubbles into the rad. No way to refill the rad by the refill port.
Any ideas, or hardware solutions they fit out of the box?
Pictures included:
Thanks for the help in advance!

 

[Vanzin]

Hi,

you can either shake your whole case in all directions to vent the system or alternative let the pump run for a few days. Normally the air bubbles will then move by themself to the highest point in your system.

 

[Alexander Madenach]

Thanks for the reply,
i trioed this aready more then one time, but if i do so, the bubbles disapeared into the rad and i was still not able to replace them with water.
So, im running out of ideas..

 

[Vanzin]

You will always have air in the system, which is normal and needed. When the radiator is the highest point in your system the air should be there, since the radaitor will work as the reservoir in this case.

 

[Alexander Madenach]

Well, good to know..
The pump is not able to press the air out of the cooler into the rad. Perhaps i manage it in the future.
Thanks a lot for the conversation !