Recent content by fr05ty

@Vanzin or @Metropolis34 sould i be concerned about the thread depth with the replacement screws that turned this week, the one on the left is what came with my eisbaer 280 edit: i just changed the mount screws over along with a new back plate i ordered and have just tested it seems to be...

If I unplug it in like in the video it goes away last time it happened was about 2-3 weeks ago, and I did the same unplug reply and it stopped, its running in an amd 3900x temps never go over about 60°c when i convert a video to test with it under load

@Vanzin would this noise be from an air bubble in the loop, as when i unplug it and re-connect it, it goes away

thank you very much for doing this, just one follow up question if i wanted to add 90 deg fittings to the pump/res what would i need to do this just so it takes the strain off the tubes going up to the rad eg. some form of liquid and 2x 90deg fittings

i recently purchased a eisbaer 280 to use on my 3900x i think the temp's might be ok it gets to 67-70 deg c when running cinebench r20, the problem is when i screwed the bracket down to the backplate 2 of the screws never stopped/got tight to turn, they give a click and can continue to turn (i...