Recent content by kubko

Okay, very good news 😎 used PTM7950 with putty on memories/vrm, reassembled the loop with correct in/out orientation and the magic happened, during the same benchmark (Timespy Graphics test 2) now I hover around 55c max, while before I was peaking at low/mid 70's under same benchmark.. GPU has...

Hello! Just a follow up post. Finally got to draining my loop and tearing GPU apart. I'll continue with loop assembly tomorrow, but I took some pics after cooler disassembly. Does it look like my core had not the best contact? Also I realized one thing, I had my inlet on incorrect port 🤦‍♂️ not...

Didn't know there are so many variables with pads sometimes its PITA to even find correct thickness leave alone hardness, my bad.. I wanna try Honeywell HT10000 putty, that should compress perfectly on memories. Rest of the pads should be fine as those are all that came precut with the block...

Hi, I recently installed waterblock on 4080 Strix. I followed instructions but made one difference. On memories instead of supplied pads I used Thermal Grizzly Minus pad Advance, however they are same thickness - 1mm. All other pads on the PCB are the one supplied. What I noticed is that TG pads...

Hi, I've recently got Aurora waterblock for the GPU. It had slight residue inside so I've decided to clean it and that cleaned fine. However, what I noticed after the reassembly few spots formed where I believe the water doesn't flow, it's just acrylic sitting on coldplate. It's the outer area...

Got it, in that case if I won't like the fountain effect I could just swap out the top tube with the longest one. So the bottom tube length practically doesn't affect anything and there's no benefit to different size here right?

Hi, I'm at stage of loop preparation for my upcoming build so I'm trying to figure out best component setup. Specifically, I want to ask about Alphacool Eisbecher Aurora D5 250 Acetal/Glass reservoir. It comes with shortest riser tube installed on its top and shorter tube on the bottom. I know...

Yep, looks like the banks are taking their time on this one. Well, shouldn't take much longer so I'll just stay patient..

Hey! So the support contacted me, completed my order and sent money through bank payment afterwards. Been few days now, could you please check on my order and if it's anywhere close to getting shipped? Thank you :)

Thank you so much, I'll be waiting.

Hello, I'm sorry as I'm probably double bombing as I've already sent e-mail. But It's quite urgent and I see you guys are active over this forum so maybe it will help solve things easier. On 9th. October I have created order 30208420, it's still being processed. Just got a paycheck and I would...