Recent content by raybould

Thank you for the reply, but this is incorrect. The board will not fit into the block with the hex shaped standoffs in there. They create a high point such that the block does not make contact with die, the thermal pads, or the other 8 standoffs used to secure the rest of the board + backplate.

I've just emailed this to info@alphacool but if anyone can help in the meantime that would be great. I ran into I think a “dead end” issue during installation. In order to get the pcb board fully seated into the block, I had to remove the 4 hex posts / risers (not sure what else to call them)...