Search results

Thank you so much <3

Good morning, I don't even have tracking number and I'm not getting answers from Alphacool in email, this is the very first time something like this happens to me with Alphacool after years buying Could you please help me?

Order number: 30208195

Good evening! Could you please provide tracking number for this order? It was ordered October 4th Thank you so much José

I just found out as long as I set it to work at 100% the whole time it won't be a problem and both won't reach 12w ever. You can close this! Thanks again

Hi there, I would like to split the Eiswolf 2 pump with another pump, the splitter will be PWM but in the BIOS I will set that connection as VOLTAGE instead of PWM so it will be running at 100% the whole time The amperage of the other pump is less than 0.30A, I don't know about the Eiswolf 2...

Thank you so much sir, I am so very surprised with the results and this is with a temperature room of 30ºC, the summer is really aggresive in south-east Spain, so it is like +3ºC only on the GPU lol Idle temps are also amazing, watching 4k videos on YT, twitch etc stays the same Good job...

Update: I had to replace my thermalpads from 1.0mm to 1.5mm, now mem temps are 64ºC full load with a delta of 30º, with 1.0mm it was 75-80 GPU never goes past 54ºC no matter what, undervolted to 1890mhz 850mv 250w instead of 320 for the same performance Pads were Thermalright and card Zotac...

I can't hear anything, just wondering if reducing the speed % can increase its life span :D Thanks Eddy

Thanks for replying Thomas, I finally installed Thermal Right pads on the front and included pads for the back side of my Zotac 3080 Holo Amp 1 hour installation, very easy and worthy. Idle 32ºC and full 50ºC (1900mhz 850mv 250w), delta temp is 29º so the Idle is +3/4ºC, impressive Mems stay...

Thank you very much for your support, I wonder if you could help me on this one: I will receive my Alphacool AIO next week for my Zotac Holo AMP 3080, I will be installing copper pads, I wonder if you know if 1mm is enough or I should go 1,25 or 1,50 for this Zotac, I'm not really sure about...