Search results

Greetings Alphacool. I’m planning tu purchase the full cover WB (Alphacool Aurora) for my new RTX 4090 Suprim card. Could you pls confirm wheter there was the block design update and what batch should I check, or the manufaturing date when the design changes were applied after? Thank you.

Thank you for the reply, Eddy. Will take a chance )) One more vital question: what's the size of a wrench to unscrew 90 degree fittings from the case of the pump module? Will swap them to compression fittings for 19/13mm tubing

Are you planning to combine the pump with this stock DC-LT? Or to remove it off the loop? Alphacool’s guy replied that it is ok to combine it with more powerful pump… I’m quite far from hydro-engineering but yet uncertain is it a good idea to combine two devices which productivity differs almost...

Thanx a lot for the link. I've placed the order. Will also try to apply proper thickness thermal pad to get some temp reduction

In the progress, waiting for the stuff to be delivered. And got another question: if one decides to turn Eiswolf's 2 water block with integrated pump module into a regular full cover block. what type of the Eisblock terminal will be required? Will the one that linked below match...

I got Eiswolf 2 installed on my 3080Ti FTW3. Did you have an issue with stock thermal pads 1mm on memory and mosfets? I had to swap it to a third party 1.25mm to achieve a decent contact. Memory temp was aweful with 1mm, over than 90 degrees, much worse than air cooled. What's your video memory...

Some of the too-old-stock on Ebay. It's brand new, just need to check if the sealing gasket didn't turn to a piece of rock )) Eventually got the reply from one of the owners of this "Frankenstein". It was designed for some old liquid-cooled PowerMac G5. Since they did't have a reservoir tank in...

Hi guys. After purchasing Alphacool Eiswolf 2 for my EVGA 3080Ti FTW3 card I found it totally disappointing in terms of the performance. I reassembled the card+waterblock 5 times to achieve even contact all over the components to be cooled (1.25mm pads instead of stock 1.0mm for mosfets and...

I removed these plastic clips and finally got a decent GPU/waterblock contact + 1.25mm thermal pads on video memory and mosfets + 1mm pads on coils. Now there's another question. I'm totally disappointed with the Eiswolf 2 kit performance. Basically the only benefit that I achieved is minus 8...

After replacing 1mm thermal pads to 1.25mm thermals situation of VRM and video memory improved significantly. 10 degrees lower than it was with the stock air cooler. The drawback now - is GPU contact pressure reduced. The temp goes higher than air-cooled. And I might have found the reason why...

Thank you for the prompt reply. Seems like thicker pads is the only solution to make this waterblock fit my graphics card. I'll email all the pic that I took, plus the invoice.

Alphacool Eiswolf 2 AIO for EVGA 3080Ti FTW3. Greetings, Alphacool. I got a question regarding the above mentioned AIO that I purchased recently. I would appreciate your comment if you’ve had similar experience in terms of the solution. I’ve installed the waterblock 3 times this far, following...