Search results

2nd post in this thread.

Yeah, water and 99999999 rpm fans. This makes sense. Recomend whole setup at first place and then tell to replace hoses, pump rad and fans...feck it, never again alpha$hit. Have a ''good'' day.

You have recommended 360mm rad with 120mm fans for 470w Gamerock 3090 and that should never happen in any case, not only I had issues with this setup.

Get one on ebay for 5$ and put it in to your water tank G 1/4 but be sure to fill tank in full. (There still will be some space left for air) (Like this one: Barrow G1/4-10k Temperature Sensor Blank Plug - Shiny Silver...

I believe you are using this: ''AlphaTube TPV and Alphacool HF'' What are your water temps at full GPU load?

Thomas_S should not recommend any setups - wasted money.

st 30 360 is ok up to 250 -300w. Xr5 420 can easly handle 400+. XR5 420 is not only longer and wider but also denser and fans are 140mm instead of 120mm, all of this makes big difference

After radiator swap from ST30 360mm and aurora fans to corsair xr5 420mm and noctua A14 140mm fans my gpu with 500w bios is max at 50c and water at 35c (temp sensor inside water tank) 1000RPM :)

Ok, I will get then ST 30 480mm. Shame that I had to spend so much ?, this loop should not be considered for 3090 at all and recommending this is a mistake. Thanks anyway, have a good day.

Can I get simple answer please how to measure water temps in this loop? Thanks.

After 1 hour of gaming in 8k I have 65C on GPU, 60C in water tank and 42C on rad. Scorching hot like for WC I would say.

Yeah but I have two readings... 30 C+ from rad and 50C + directly from water. If I have to trust to temps from water then I am ''near the border of 60C'' but if from rad then I have a lot of headroom.

If limit for components is 60c then I believe as water has direct contact with them I should trust to temps directly from the pump reservoir :)

Temps of water in pump and on rad, 15c difference. Game in 8k. https://ibb.co/8BjHvDb https://ibb.co/FDmHxFP https://ibb.co/tXPH94K

Both, water temps and core temp, thanks

I have 50+ C water in reservoir, 35c on the rad, difference is quite big, ambiant temps will go down, at the moment is hot in UK but not for long. Thanks for advice regarding hoses. Last question. What temps under full load are normal for 3090 and Eiswolf 2?

That will not be temp of water but of radiator... 10c less as minimum if not much more. 3 fans are pushing out the air and noctua dh 15 chromax that is below them is cold always. https://ibb.co/Ryfth2b

Also I have no idea how to reduce the number of quick-release fasteners. Could you advice please?

I am just wondering how to put sensor diode in the reservoir and close the cap. Inside water has 50c +, outside on the wall of the reservoir 40+c but this is on 400w load (4k + RT NO DLSS) Ambiant today is 30C.

Is this ok to check temps of water in the pump reservoir when system is running? (unscrewed reservoir cap) I do use Commander Pro temp diode and device. https://ibb.co/StfCNpK Thanks