Rodalucaye
New member
Hi,
it is compatible with some water block ?
Thanks.
it is compatible with some water block ?
Thanks.
Asrock Radeon RX 6800 XT Taichi X OC 16GB GDDR6
- Thread starter Rodalucaye
- Start date
Rodalucaye
New member
if you want i send you a photo of the pcb, if it's help.
That would be great 
Than we can check if a block could fit or not. But to be honest. Please to: info@alphacool.com
Than we can check if a block could fit or not. But to be honest. Please to: info@alphacool.com
Padge
New member
The 6800 XT Taichi X OC and the 6900 XT Phantom OC both share the same PCB.
ibb.co
EKWB could be making a compatible block. I adapted the corsair 6800/6900 reference waterblock to fit. Remove the metal shroud, shave the acrylic so the two longer capacitors fit, then the holes line up perfectly to fit tight to the board, with great contact. I connected the in/out tubing to the underside, as the PCB covers the upper side.
Both the temps and noise are now amazing, running just shy of 2700 on the core, barely a whisper from my rig!
ASRock-Radeon-RX-6800-XT-Taichi-X-PCB
Image ASRock-Radeon-RX-6800-XT-Taichi-X-PCB hosted in ImgBB
ibb.co
EKWB could be making a compatible block. I adapted the corsair 6800/6900 reference waterblock to fit. Remove the metal shroud, shave the acrylic so the two longer capacitors fit, then the holes line up perfectly to fit tight to the board, with great contact. I connected the in/out tubing to the underside, as the PCB covers the upper side.
Both the temps and noise are now amazing, running just shy of 2700 on the core, barely a whisper from my rig!
Last edited:
Rodalucaye
New member
Thanks for the reply mate!
Padge
New member
No problem, if you want to do the same, you just need a dremel to carefully shave the acrylic, everything else is just easy
The original thread is here:
I did the same, but a little neater! Haha
The original thread is here:
I did the same, but a little neater! Haha