Eiswolf 2 360 + Eisbaer Aurora 360+ NexXxos ST30 280 in O11D Mini

ChickenDoner

New member
I am using an ITX motherboard with 5-slot configuration inside the O11D Mini
11730: Eisbaer Aurora 360 CPU - Digital RGB
11931: Eiswolf 2 AIO - 360mm RTX 3090/3080 with backplate (Reference)
14371: NexXxos ST30 Full Copper 280mm prefilled AIO Edition

I have few questions:
1. Are the 2 pumps powerful enough to drive all 3 radiators in a single loop?
2. If I have radiators on all of the bottom (intake), side (intake) and top (exhaust) with a rear exhaust fan or no fan, will I have enough case airflow for DIMMs and SSD etc?
3. If I have bottom exhaust, side intake, top intake and rear exhaust (or no fan?), would that be better overall and especially for DIMMs and SSD etc?
4. What coolant is used in these prefilled products?
5. How do I refill coolant into the system? I only see fill port on the CPU pump but not GPU block and radiators
6. Do I need any extra parts? (example 14371 tubings look short)

Thanks
 
Last edited:

Eddy

Iceman
Staff member
1. Yes
2. With 3 radiators you will have 8 fans in your case.... i have only 5 in my case with over 500W waste of heat and a few SSDs... so yes, its enough.
3. Your DIMMs need no direct cooling. If DIMMs need an activ cooling they are bad.
4. Similar to Apex Liquid ECO. Only mixed with a bit osmose water.
5. If you put everything together, you can fill it over the Fill Port on the Eisbaer. Yeah, its a bit tricky, but its possible.
6. Really not sure. But i "think" you will not need extra tubes. The O11D Mini is very small, no long ways for the tubes.
 
Top