BobbyBoyGaming
Member
Hello,
Is there a way to change the final position of a non rotatable fitting such as this one?
If I put an additional o-ring would that work to change it's final direction?
Is there an official way to make these work? Perhaps fat o-rings or some type of washer/spacer
I like these because they are very low profile, but the disadvantage is that you never know how they end up orientated in a fully tightened state.
Can you please develop a fat o-ring or something to help with this? If you have a suggestion please tell me.
Is there a way to change the final position of a non rotatable fitting such as this one?
If I put an additional o-ring would that work to change it's final direction?
Is there an official way to make these work? Perhaps fat o-rings or some type of washer/spacer
I like these because they are very low profile, but the disadvantage is that you never know how they end up orientated in a fully tightened state.
Can you please develop a fat o-ring or something to help with this? If you have a suggestion please tell me.