Hi,I just purchased the Eisbaer Extreme 280. When I was trying to install it,I noticed 3 cables goes out from the radiatoer/cooling unit:1x4 pin with 4 wires; 1x4 pin with 2 wires and 1xMolex connection. My question is where am I supposed to plug the moles wire? By using an extension line connected to the PSU? or some special ones?
About Eisbaer Extreme 280 installation
- Thread starter GA_Dantes
- Start date
Hi @GA_Dantes
The molex connector is for the power supply of the built-in VPP755 pump, this should be connected to the power supply.
The connector with the 2 cables is to read and regulate the pump speed, which comes on a free 4-pin fan connector on the mainboard. And the plug with the 4 cables are for the two built-in fans, if you use the Eisbaer Extreme for the CPU, this comes on the CPU fan header on the mainboard or on another 4-pin fan connector.
Best Regards
The molex connector is for the power supply of the built-in VPP755 pump, this should be connected to the power supply.
The connector with the 2 cables is to read and regulate the pump speed, which comes on a free 4-pin fan connector on the mainboard. And the plug with the 4 cables are for the two built-in fans, if you use the Eisbaer Extreme for the CPU, this comes on the CPU fan header on the mainboard or on another 4-pin fan connector.
Best Regards
Oh,I see.
Thanks for your reply @Luckystricker Yeah,I'm gonna install it on my 5900x. The only connector that confused me is the molex one,so it should be connected to the power supply,I see. Time to get my extension line.
Thanks for your reply @Luckystricker Yeah,I'm gonna install it on my 5900x. The only connector that confused me is the molex one,so it should be connected to the power supply,I see. Time to get my extension line.