Eisbaer LT360 - Pump failure

Status
Not open for further replies.

Tomas

New member
Hi,

So i think the pump on my LT360 has failed. I was first alerted when temp alarms started going off as my CPU hit 80c. Checking the sensors I had no reading from the AIO power sensor or flow sensors, they all showed 0. Fans on the radiator were all turning and I had sensor readings for all of them.

This is a new build assembled in March. The pump was working fine until now, usually the radiator gets warm as well as the top of the case. Now the radiator & case are cool but the water block on the CPU is too hot to touch.
 

Tomas

New member
Just writing to say Thank You!

Got the replacement waterblock a week later. Found some Youtube videos on how to drain/fill the new one and installed it easily. I've been running it for just over a week now with no problems or leeks so all good!

Many thanks for the quick turnaround!
 
Status
Not open for further replies.
Top