Eisblock Aurora Acryl RGB plug

[Roshol]

Hello,

I ordered the Eisblock Aurora Acryl for RTX 3080 FE and I would like to know if I can plug the RGB connector (3-pin jst 5V according to the manual) to this controller :

https://fr.aliexpress.com/item/32971783441.html?spm=a2g0w.12010612.8148356.3.197f55dfI3cOJ9



I don't know if it's physically possible to plug it like the upper figure. What should I buy if it's not possible? my asus motherboard only have 4pin 5v header.

Thank you in advance for your help.

Roshol

 

[Eddy]

Seems like Barrow is using own connectors, so please ask Barrow for help.

If your mainboard has a 4-Pin connector than its a 12V RGB header not aRGB. but you can use any aRGB controller with normal 3-Pin 5V connectors. Or you can use our Eis Matrix II or our small simple connector: https://www.alphacool.com/shop/modd...a-eiscontrol-addressable-rgb-controller-black

 

[Roshol]

Seems like Barrow is using own connectors, so please ask Barrow for help.

If your mainboard has a 4-Pin connector than its a 12V RGB header not aRGB. but you can use any aRGB controller with normal 3-Pin 5V connectors. Or you can use our Eis Matrix II or our small simple connector: https://www.alphacool.com/shop/modd...a-eiscontrol-addressable-rgb-controller-black

Thank you for your answer, my motherboard have a 5v 4pins connector as following:


So I suppose the connector you sent me would fit, but do you have just the cable without the controller? Thank you.

edit : sorry for the misunderstanding, the connector of my motherboard is a 3 pin but it take 4 slot.

 

[Luckystricker]

Hi @Roshol

For that you need this cable.
You just have to be careful that your parts also have the JST connector.
No more than 120 LEDs or 3 A total power may be connected to one connector on the mainboard.

Alphacool Digital RGB LED Y-Kabel 3-fach mit JST Stecker - Schwarz 30cm

Wer seine adressierbaren Digitalen RGB-LEDs über einen Controller ansteuern will, benötigt einen passenden Digital-RGB Y-Adapter. Der 3-fach Splitter erlaubt das Anschließen von bis zu 3 aRGB Produkten an einem Controller. Das Kabel kann...

www.alphacool.com

Best Regards

 

[Eddy]

@Roshol
That 3-Pin Connector wich uses 4 slots is the typical 3-Pin 5V aRGB Header. I know this can be irritating and many people don't get along with the new connections for argb. But this is exactly the classic aRGB 3-pin 5V connection.

 

[Roshol]

Thank you, I will go for the cable linked by luckystricker, it seems to fit my need.