i have a gaming ax x gigabyte b650m maotherboard and have connected the PUM Alphacool Core 200 Aurora reservoir acetal/acrylic on the cpu_fan pins. although it works i cannot seem to have access to set a curve or see the rpms of the pump in bios. gigabyte control center not shoow it too, hwinfo64 either says no fan rpms. on another sys_fan1,2 etc even if i have put it does not work too. i have installed an aio eisbaer cpu pump and it shows rpms. Does it need rng or i dso soemthign special to get them?>
PUM Alphacool Core 200
- Thread starter ckinfos
- Start date
Actually, you did everything correctly. The RPM should be readable and the pump should be controllable via PWM. You could try connecting the pump to the same header as the Eisbaer to check whether the motherboard header might be defective. If it still does not work there, you will likely need to replace the pump. In that case, I would suspect a broken cable somewhere.