Second radiator with Eisbaer pro aurora 360

[kojiki23]

Hello,

Context:
I've ordered the Eisbaer pro aurora 360 and I recently ordered the NexXxos ST30 to add a second radiator.
I'm looking at installing:

• the first radiator at the top of my case, connectors on the right;
• the second radiator on the front of my case, connectors at the top.

Issue:
When I install the two, the tube linking the two radiators is very short and rigid (due to the quick release connector). The tube end up being bent in a way that would prevent any fluid to circulate.

Question:
I've considered the following solutions:

1. An angled connector to keep the tube straights
2. An extension cable and flipping the second radiator so the tube are coming from the bottom.

Can anyone point me to the right components to buy in order to implement any of those two solutions?
I'm also open to any alternative solution.

Best,

 

[Thomas_S]

... or you can try variant 3.... ;-)

Simply remove the quick coupling, adjust the tube to the required length and connect the tube to the 2nd radiator with the appropriate fittings.

Please send a picture of your setup ;-) to look for further solutions.