chapulinho
New member
Hello everyone,
I just bought the "Alphacool Eisbecher DDC 150mm Acetal inkl. 1x Alphacool DDC310". So far everything is clear and good, but I have one doubt that I couldn't eliminate with all my internet investigation:
At the front there is one outgoing connection and one ingoing (both are marked). At the exact opposit side, there is another 1/4'' connection with also a female thread. As I unboxed it, this connection was closed with a std-nipple.
Here my question(s): What is the purpose of that connection? There is no info in the instrucion neither an information on the product.
I would like to integrate a valve into my loop, to facilitate water-change or maintenance in general, in case I want to change the loop. Can I use this connection to connect a ball valve?
Its the only/best spot where I could connect it.
Thanks a lot in advance!
I just bought the "Alphacool Eisbecher DDC 150mm Acetal inkl. 1x Alphacool DDC310". So far everything is clear and good, but I have one doubt that I couldn't eliminate with all my internet investigation:
At the front there is one outgoing connection and one ingoing (both are marked). At the exact opposit side, there is another 1/4'' connection with also a female thread. As I unboxed it, this connection was closed with a std-nipple.
Here my question(s): What is the purpose of that connection? There is no info in the instrucion neither an information on the product.
I would like to integrate a valve into my loop, to facilitate water-change or maintenance in general, in case I want to change the loop. Can I use this connection to connect a ball valve?
Its the only/best spot where I could connect it.
Thanks a lot in advance!
