Recent content by w_o_t_q

Just got the Corsair block. It is a hybrid one. GPU/RAM water-cooled, and air-cooled other PCB elements (See the slits in the second picture; this channel pushes air from the front ventilator against PCB elements). Right now, wait for other components to start building. Corsair hub to run the...

I found that this will work: https://www.corsair.com/us/en/explorer/diy-builder/custom-cooling/xg3-hybrid-50-series-water-block-gpu-compatibility. When I disassemble a card before installing the Corsair block, I can add pictures of the PCB in this thread. Maybe the existing 5070 GPU block might...

Thanks for the reply!

Which alphacool water GPU block, if it exists? Quick disconnect for draining the Corsair pump reservoir combo G1/4, if it exists preferable short one?

I dissembled loop and put it together on table top only configuration will work was pump vertical gpu block and 280 mm rad, or replace GPU rad with cpu ... Other configurations did not work, speed maximum by water flow visible in reservoir. Later I will buy EKWB small combo for 120 mm rad and...

Basically problem is that this this pump on max can serve only gpu block and 280 rad for other elements need another pump

Yes, Eisfluegel. I think from factory speed is on max? beside it was dry run, just custom loop elements pump, it is audible so i assume that it is on max speed

Put together this loop, flow meter show no flow, there are no air bubbles all tubes 13/10 is full(soft) about hardware 280 mm and 120 mm 45 thick alphacool rads, xpx cpu block and vga radiator N01 series, reservoir combo Alphacool Eisstation VPP with Alphacool Eispumpe VPP755. What wrong with...