timrainer
New member
I was trying to swap the pump of the Eisbaer Solo LT to the 3600 rpm version and I do understand the noise of it is much louder.
However, I do found it very hard to tear down the plastic top shield shown in the picture attached here.
I had looked into the structural design of this block yet I did find that there is actually no screw that is holding this plate on the block. Therefore, I don't know what is the proper way to do this, should I use heat gun because it might be glued? Or I need to push harder.
Looking forward to a gentle solution that is not going to do some structural damage.
Or I actually cannot tear it down.
Thanks in advance.
However, I do found it very hard to tear down the plastic top shield shown in the picture attached here.
I had looked into the structural design of this block yet I did find that there is actually no screw that is holding this plate on the block. Therefore, I don't know what is the proper way to do this, should I use heat gun because it might be glued? Or I need to push harder.
Looking forward to a gentle solution that is not going to do some structural damage.
Or I actually cannot tear it down.
Thanks in advance.