Recent content by IcyStorm

Nop dont use that buy PTM 7950, this is the only thing that will help you....ANY paste will pump-out or burn on 110C and such pressure...

Sadly i received that same block for Taichi with scratches and chopped acrylic standoff... so heads up team, please make sure quality control is better in the future...

That is ok dude! P.s that bubble is your new spiritual animal, it will not go away! : D

For a reasons like this i posted this topic - I believe the company can do more to help out its customers as the process can be quite problematic.. https://forum.alphacool.com/threads/returned-shippment-not-accepted.4788/#post-27162

After many ups and downs, i received a replacement of my ASRock XTX Taichi AIO block, i would like to say that i switch to PTM 7950 and i am happy for now - @ 465W - 88 Hot spot / 69C board. That is for first time for more then 1 year of issues... - Taichi fans are crap, the first one start...

Hi all, I was advised to RMA my GPU AIO, few questions as the web site is way too slow, and i get response for Info@alphacool, every 4-5 days... 1. Do i need to use the original package of the AIO or just a safe one? 2. There is two documents i need to include inside the box the RMA request...

My AIO just got chips in it, so i am filling a report with Alphacool...in case they send me a replacement i would start with Honeywell PTM7950...paste for the AIO is waste of time and no good....

I have XTX ASRock Taichi with AIO Block - i have the following results after re-pasting with Noctua H2: Idle - 33C board / hot spot 36C on 23 ambient temps. Load 100%, + 15% power limit /455W~/- CP2077/RDR2, or OCCT test - 72C Board / 92C hot spot. *This is my best achievement up-until...

Hi all, I have an issue accessing the https://shop.alphacool.com/en/shop/ from Bulgaria currently, a Greece friend is in the same situation, but when i use VPN and access it from Netherlands, i dont have a problem? @ Alphacool?

I have high temps(on hot spot only) 95C++ on high loads only - CP27 etc. Most ppl with waterblocks dont have that problems...

I have proper 1mm and 3mm for the PCB, propely installed according to the manual. (Exactly followed as a good German!) I would like to change the paste of the GPU only. To this - https://www.thermal-grizzly.com/en/products/516-minus-pad-extreme-en The minus pad extreme is electrically...

Hi Vanzin, If all that small details where in our manuals, we would not blame at Alphacool right a way, but seek a solution right? We are all reasonable people here...I spend hours investigating why i have high hot spot temps, without understanding what is going on... The worst is all solutions...

@blackwell1988 @DirtyAlpaca I have, some 0.5mm Thermal Grizzly Extreeme, around here. Can i use it directly for the GPU hot spot...? Some of the ppl here use paste again, some of you use 7950 Honeywell...I am confused, lots of ppl on youtube state that pads are bad for CPU and GPU's...

Hi Vanzin, Thanks for your response, but would you please revert back on point 1 and 4...?

Hi all, I have a ASRock Taichi 7900 XTX OC and i would like to see if anyone resolved the issue with the - 1/ high delta between gpu temp and hotspot, in my case its 30C ~. 2/ On CP 4k ULTRA RT - i get up to 105C hot spot, and i am not happy with it... Questions for the tech support: 1. In...